Phase slips occur across all Josephson junctions (JJs) at a rate that increases with the impedance of the junction. In superconducting qubits composed of JJ-array superinductors —such as fluxonium — phase slips in the array can lead to decoherence. In particular, phase-slip processes at the individual array junctions can coherently interfere, each with an Aharonov–Casher phase that depends on the offset charges of the array islands. These coherent quantum phase slips (CQPS) perturbatively modify the qubit frequency, and therefore charge noise on the array islands will lead to dephasing. By varying the impedance of the array junctions, we design a set of fluxonium qubits in which the expected phase-slip rate within the JJ-array changes by several orders of magnitude. We characterize the coherence times of these qubits and demonstrate that the scaling of CQPS-induced dephasing rates agrees with our theoretical model. Furthermore, we perform noise spectroscopy of two qubits in regimes dominated by either CQPS or flux noise. We find the noise power spectrum associated with CQPS dephasing appears to be featureless at low frequencies and not 1/f. Numerical simulations indicate this behavior is consistent with charge noise generated by charge-parity fluctuations within the array. Our findings broadly inform JJ-array-design tradeoffs, relevant for the numerous superconducting qubit designs employing JJ-array superinductors.
Robust and scalable multiplexed qubit readout will be essential to the realization of a fault-tolerant quantum computer. To this end, we propose and demonstrate transmission-based dispersivereadout of a superconducting qubit using an all-pass resonator that preferentially emits readout photons in one direction. This is in contrast to typical readout schemes, which intentionally mismatch the feedline at one end so that the readout signal preferentially decays toward the output. We show that this intentional mismatch creates scaling challenges, including larger spread of effective resonator linewidths due to non-ideal impedance environments and added infrastructure for impedance matching. Our proposed „all-pass readout“ architecture avoids the need for intentional mismatch and aims to enable reliable, modular design of multiplexed qubit readout, thus improving the scaling prospects of quantum computers. We design and fabricate an all-pass readout resonator that demonstrates insertion loss below 1.17 dB at the readout frequency and a maximum insertion loss of 1.53 dB across its full bandwidth for the lowest three states of a transmon qubit. We demonstrate qubit readout with an average single-shot fidelity of 98.1% in 600 ns; to assess the effect of larger dispersive shift, we implement a shelving protocol and achieve a fidelity of 99.0% in 300 ns.
Quantum information processing at scale will require sufficiently stable and long-lived qubits, likely enabled by error-correction codes. Several recent superconducting-qubit experiments,however, reported observing intermittent spatiotemporally correlated errors that would be problematic for conventional codes, with ionizing radiation being a likely cause. Here, we directly measured the cosmic-ray contribution to spatiotemporally correlated qubit errors. We accomplished this by synchronously monitoring cosmic-ray detectors and qubit energy-relaxation dynamics of 10 transmon qubits distributed across a 5x5x0.35 mm3 silicon chip. Cosmic rays caused correlated errors at a rate of 1/(10 min), accounting for 17±1% of all such events. Our qubits responded to essentially all of the cosmic rays and their secondary particles incident on the chip, consistent with the independently measured arrival flux. Moreover, we observed that the landscape of the superconducting gap in proximity to the Josephson junctions dramatically impacts the qubit response to cosmic rays. Given the practical difficulties associated with shielding cosmic rays, our results indicate the importance of radiation hardening — for example, superconducting gap engineering — to the realization of robust quantum error correction.