Microwave squeezing represents the ultimate sensitivity frontier for superconducting qubit measurement. However, observation of enhancement has remained elusive, in part because integrationwith conventional dispersive readout pollutes the signal channel with antisqueezed vacuum. Here we induce a stroboscopic light-matter coupling with superior squeezing compatibility, and observe an increase in the room-temperature signal-to-noise ratio of 24%. Squeezing the orthogonal phase controls measurement backaction, slowing dephasing by a factor of 1.8. This protocol enables the practical use of microwave squeezing for qubit state measurement.
Single-mode Josephson junction-based parametric amplifiers are often modeled as perfect amplifiers and squeezers. We show that, in practice, the gain, quantum efficiency, and outputfield squeezing of these devices are limited by usually neglected higher-order corrections to the idealized model. To arrive at this result, we derive the leading corrections to the lumped-element Josephson parametric amplifier of three common pumping schemes: monochromatic current pump, bichromatic current pump, and monochromatic flux pump. We show that the leading correction for the last two schemes is a single Kerr-type quartic term, while the first scheme contains additional cubic terms. In all cases, we find that the corrections are detrimental to squeezing. In addition, we show that the Kerr correction leads to a strongly phase-dependent reduction of the quantum efficiency of a phase-sensitive measurement. Finally, we quantify the departure from ideal Gaussian character of the filtered output field from numerical calculation of third and fourth order cumulants. Our results show that, while a Gaussian output field is expected for an ideal Josephson parametric amplifier, higher-order corrections lead to non-Gaussian effects which increase with both gain and nonlinearity strength. This theoretical study is complemented by experimental characterization of the output field of a flux-driven Josephson parametric amplifier. In addition to a measurement of the squeezing level of the filtered output field, the Husimi Q-function of the output field is imaged by the use of a deconvolution technique and compared to numerical results. This work establishes nonlinear corrections to the standard degenerate parametric amplifier model as an important contribution to Josephson parametric amplifier’s squeezing and noise performance.
Harnessing the full power of nascent quantum processors requires the efficient management of a limited number of quantum bits with finite lifetime. Hybrid algorithms leveraging classicalresources have demonstrated promising initial results in the efficient calculation of Hamiltonian ground states–an important eigenvalue problem in the physical sciences that is often classically intractable. In these protocols, a Hamiltonian is parsed and evaluated term-wise with a shallow quantum circuit, and the resulting energy minimized using classical resources. This reduces the number of consecutive logical operations that must be performed on the quantum hardware before the onset of decoherence. We demonstrate a complete implementation of the Variational Quantum Eigensolver (VQE), augmented with a novel Quantum Subspace Expansion, to calculate the complete energy spectrum of the H2 molecule with near chemical accuracy. The QSE also enables the mitigation of incoherent errors, potentially allowing the implementation of larger-scale algorithms without complex quantum error correction techniques.
We consider the temporal correlations of the quantum state of a qubit subject to simultaneous continuous measurement of two non-commuting qubit observables. Such qubit state correlatorsare defined for an ensemble of qubit trajectories, which has the same fixed initial state and can also be optionally constrained by a fixed final state. We develop a stochastic path integral description for the continuous quantum measurement and use it to calculate the considered correlators. Exact analytic results are possible in the case of ideal measurements of equal strength and are also shown to agree with solutions obtained using the Fokker-Planck equation. For a more general case with decoherence effects and inefficiency, we use a diagrammatic approach to find the correlators perturbatively in the quantum efficiency. We also calculate the state correlators for the quantum trajectories which are extracted from readout signals measured in a transmon qubit experiment, by means of the quantum Bayesian state update. We find an excellent agreement between the correlators based on the experimental data and those obtained from our analytical and numerical results.
The quantum Zeno effect is the suppression of Hamiltonian evolution by repeated observation, resulting in the pinning of the state to an eigenstate of the measurement observable. Usingmeasurement only, control of the state can be achieved if the observable is slowly varied such that the state tracks the now time-dependent eigenstate. We demonstrate this using a circuit-QED readout technique that couples to a dynamically controllable observable of a qubit. Continuous monitoring of the measurement record allows us to detect an escape from the eigenstate, thus serving as a built-in form of error detection. We show this by post-selecting on realizations with arbitrarily high fidelity with respect to the target state. Our dynamical measurement operator technique offers a new tool for numerous forms of quantum feedback protocols, including adaptive measurements and rapid state purification.
We consider the simultaneous and continuous measurement of qubit observables σz and σzcosφ+σxsinφ, focusing on the temporal correlations of the two output signals. Using quantumBayesian theory, we derive analytical expressions for the correlators, which we find to be in very good agreement with experimentally measured output signals. We further discuss how the correlators can be applied to parameter estimation, and use them to infer a small residual qubit Hamiltonian arising from calibration inaccuracy in the experimental data.
The direct measurement of topological invariants in both engineered and naturally occurring quantum materials is a key step in classifying quantum phases of matter. Here we motivatea toolbox based on time-dependent quantum walks as a method to digitally simulate single-particle topological band structures. Using a superconducting qubit dispersively coupled to a microwave cavity, we implement two classes of split-step quantum walks and directly measure the topological invariant (winding number) associated with each. The measurement relies upon interference between two components of a cavity Schr\“odinger cat state and highlights a novel refocusing technique which allows for the direct implementation of a digital version of Bloch oscillations. Our scheme can readily be extended to higher dimensions, whereby quantum walk-based simulations can probe topological phases ranging from the quantum spin Hall effect to the Hopf insulator.
The topology of a single-particle band structure plays a fundamental role in understanding a multitude of physical phenomena. Motivated by the connection between quantum walks and suchtopological band structures, we demonstrate that a simple time-dependent, Bloch-oscillating quantum walk enables the direct measurement of topological invariants. We consider two classes of one-dimensional quantum walks and connect the global phase imprinted on the walker with its refocusing behavior. By disentangling the dynamical and geometric contributions to this phase we describe a general strategy to measure the topological invariant in these quantum walks. As an example, we propose an experimental protocol in a circuit QED architecture where a superconducting transmon qubit plays the role of the coin, while the quantum walk takes place in the phase space of a cavity.
In quantum mechanics, measurement restores a classical notion of reality via collapse of the wavefunction, which yields a precisely defined outcome. On the other hand, the Heisenberguncertainty principle dictates that incompatible observables, such as position and momentum, cannot both take on arbitrarily precise values. But how does a wavefunction evolve when two such quantities are probed simultaneously, and how does the uncertainty principle dynamically inhibit precise measurement outcomes? To realize this unexplored regime, we simultaneously apply two continuous quantum non-demolition probes of non-commuting observables on a superconducting qubit. We achieve this capability by developing a novel measurement scheme that allows us to control the axes of multiple readout channels. We show that the uncertainty principle directly governs the dynamics of the state, and consequently standard wavefunction collapse is replaced by a persistent diffusion that exhibits several distinct regimes. Although evolution of the state now differs drastically from that of a conventional measurement, information about both non-commuting observables is extracted by keeping track of the time ordering of the measurement record, enabling quantum state tomography without alternating measurements. Our work creates new capabilities for quantum control, including rapid state purification, adaptive measurement, measurement-based state steering and continuous quantum error correction. As physical quantum systems interact with their environments via non-commuting degrees of freedom, our work offers a new, more natural approach to experimentally study contemporary quantum foundations.
We present a systematic study of the effects of shielding on the internal quality factors (Qi) of Al and TiN microwave resonators designed for use in quantum coherent circuits. Measurementswere performed in an adiabatic demagnetization refrigerator, where typical magnetic fields of 200 {\mu}T are present at the unshielded sample stage. Radiation shielding consisted of 100 mK and 500 mK Cu cans coated with infrared absorbing epoxy. Magnetic shields consisted of Cryoperm 10 and Sn plating of the Cu cans. A 2.7 K radiation can and coaxial thermalization filters were present in all measurements. TiN samples with Qi = 1.3∗106 at 100 mK exhibited no significant variation in quality factor when tested with limited shielding. In contrast, Al resonators showed improved Qi with successive shielding, with the largest gains obtained from the addition of the first radiation and magnetic shields and saturating before the addition of Sn plating infrared absorbing epoxy.