The advancement of scalable quantum information processing relies on the accurate and parallel manipulation of a vast number of qubits, potentially reaching into the millions. Superconductingqubits, traditionally controlled through individual circuitry, currently face a formidable scalability challenge due to the excessive use of wires. This challenge is nearing a critical point where it might soon surpass the capacities of on-chip routing, I/O packaging, testing platforms, and economically feasible solutions. Here we introduce a multiplexed control scheme that efficiently utilizes shared control lines for operating multiple qubits and couplers. By integrating quantum hardware-software co-design, our approach utilizes advanced techniques like frequency multiplexing and individual tuning. This enables simultaneous and independent execution of single- and two-qubit gates with significantly simplified wiring. This scheme has the potential to diminish the number of control lines by one to two orders of magnitude in the near future, thereby substantially enhancing the scalability of superconducting quantum processors.
Quantum computation architecture based on d-level systems, or qudits, has attracted considerable attention recently due to their enlarged Hilbert space. Extensive theoretical and experimentalstudies have addressed aspects of algorithms and benchmarking techniques for qudit-based quantum computation and quantum information processing. Here, we report a physical realization of qudit with upto 4 embedded levels in a superconducting transmon, demonstrating high-fidelity initialization, manipulation, and simultaneous multi-level readout. In addition to constructing SU(d) operations and benchmarking protocols for quantum state tomography, quantum process tomography, and randomized benchmarking etc, we experimentally carry out these operations for d=3 and d=4. Moreover, we perform prototypical quantum algorithms and observe outcomes consistent with expectations. Our work will hopefully stimulate further research interest in developing manipulation protocols and efficient applications for quantum processors with qudits.
Implementing arbitrary single-qubit gates with near perfect fidelity is among the most fundamental requirements in gate-based quantum information processing. In this work, we fabrica transmon qubit with long coherence times and demonstrate single-qubit gates with the average gate error below 10−4, i.e. (7.42±0.04)×10−5 by randomized benchmarking (RB). To understand the error sources, we experimentally obtain an error budget, consisting of the decoherence errors lower bounded by (4.62±0.04)×10−5 and the leakage rate per gate of (1.16±0.04)×10−5. Moreover, we reconstruct the process matrices for the single-qubit gates by the gate set tomography (GST), with which we simulate RB sequences and obtain single-qubit fedlities consistent with experimental results. We also observe non-Markovian behavior in the experiment of long-sequence GST, which may provide guidance for further calibration. The demonstration extends the upper limit that the average fidelity of single-qubit gates can reach in a transmon-qubit system, and thus can be an essential step towards practical and reliable quantum computation in the near future.
Accurate control of qubits is the central requirement for building functional quantum processors. For the current superconducting quantum processor, high-fidelity control of qubitsis mainly based on independently calibrated microwave pulses, which could differ from each other in frequencies, amplitudes, and phases. With this control strategy, the needed physical source could be challenging, especially when scaling up to large-scale quantum processors is considered. Inspired by Kane’s proposal for spin-based quantum computing, here, we explore theoretically the possibility of baseband flux control of superconducting qubits with only shared and always-on microwave drives. In our strategy, qubits are by default far detuned from the drive during system idle periods, qubit readout and baseband flux-controlled two-qubit gates can thus be realized with minimal impacts from the always-on drive. By contrast, during working periods, qubits are tuned on resonance with the drive and single-qubit gates can be realized. Therefore, universal qubit control can be achieved with only baseband flux pulses and always-on shared microwave drives. We apply this strategy to the qubit architecture where tunable qubits are coupled via a tunable coupler, and the analysis shows that high-fidelity qubit control is possible. Besides, the baseband control strategy needs fewer physical resources, such as control electronics and cooling power in cryogenic systems, than that of microwave control. More importantly, the flexibility of baseband flux control could be employed for addressing the non-uniformity issue of superconducting qubits, potentially allowing the realization of multiplexing and cross-bar technologies and thus controlling large numbers of qubits with fewer control lines. We thus expect that baseband control with shared microwave drives can help build large-scale superconducting quantum processors.
Crosstalk is a major concern in the implementation of large-scale quantum computation since it can degrade the performance of qubit addressing and cause gate errors. Finding the originof crosstalk and separating contributions from different channels are essential prerequisites for figuring out crosstalk mitigation schemes. Here, by performing circuit analysis of two coupled floating transmon qubits, we demonstrate that, even if the stray coupling, e.g., between a qubit and the drive line of its nearby qubit, is absent, microwave crosstalk between qubits can still exist due to the presence of a spurious crosstalk channel. This channel arises from free modes, which are supported by the floating structure of transmon qubits, i.e., the two superconducting islands of the qubits have no galvanic connection to the ground. For various geometric layouts of floating transmon qubits, we give the contributions of microwave crosstalk from the spurious channel and show that this channel can become a performance-limiting factor in qubit addressing. This research could provide guidance for suppressing microwave crosstalk between floating superconducting qubits through the design of qubit circuits.
With the long coherence time, fixed-frequency transmon qubit is a promising qubit modality for quantum computing. Currently, diverse qubit architectures that utilize fixed-frequencytransmon qubits have been demonstrated with high-fidelity gate performance. Nevertheless, the relaxation times of transmon qubits can have large temporal fluctuations, causing instabilities in gate performance. The fluctuations are often believed to be caused by nearly on-resonance couplings with sparse two-level-system (TLS) defects. To mitigate their impact on qubit coherence and gate performance, one direct approach is to tune the qubits away from these TLSs. In this work, to combat the potential TLS-induced performance fluctuations in a tunable-bus architecture unitizing fixed-frequency transmon qubits, we explore the possibility of using an off-resonance microwave drive to effectively tuning the qubit frequency through the ac-Stark shift while implementing universal gate operations on the microwave-dressed qubit. We show that the qubit frequency can be tuned up to 20 MHz through the ac-stark shift while keeping minimal impacts on the qubit control. Besides passive approaches that aim to remove these TLSs through more careful treatments of device fabrications, this work may offer an active approach towards mitigating the TLS-induced performance fluctuations in fixed-frequency transmon qubit devices.
Maintaining or even improving gate performance with growing numbers of parallel controlled qubits is a vital requirement towards fault-tolerant quantum computing. For superconductingquantum processors, though isolated one- or two-qubit gates have been demonstrated with high-fidelity, implementing these gates in parallel commonly show worse performance. Generally, this degradation is attributed to various crosstalks between qubits, such as quantum crosstalk due to residual inter-qubit coupling. An understanding of the exact nature of these crosstalks is critical to figuring out respective mitigation schemes and improved qubit architecture designs with low crosstalk. Here we give a theoretical analysis of quantum crosstalk impact on simultaneous gate operations in a qubit architecture, where fixed-frequency transmon qubits are coupled via a tunable bus, and sub-100-ns controlled-Z (CZ) gates can be realized by applying a baseband flux pulse on the bus. Our analysis shows that for microwave-driven single qubit gates, the dressing from qubit-qubit coupling can cause non-negligible cross-driving errors when qubits operate near frequency collision regions. During CZ gate operations, although unwanted near-neighbor interactions are nominally turned off, sub-MHz parasitic next-near-neighbor interactions involving spectator qubits can still exist, causing considerable leakage or control error when one operates qubit systems around these parasitic resonance points. To ensure high-fidelity simultaneous operations, this could rise a request to figure out a better way to balance the gate error from target qubit systems themselves and the error from non-participating spectator qubits. Overall, our analysis suggests that towards useful quantum processors, the qubit architecture should be examined carefully in the context of high-fidelity simultaneous gate operations in a scalable qubit lattice.
Floquet engineering, i.e. driving the system with periodic Hamiltonians, not only provides great flexibility in analog quantum simulation, but also supports phase structures of greatrichness. It has been proposed that Floquet systems can support a discrete time-translation symmetry (TTS) broken phase, dubbed the discrete time crystal (DTC). This proposal, as well as the exotic phase, has attracted tremendous interest among the community of quantum simulation. Here we report the observation of the DTC in an one-dimensional superconducting qubit chain. We experimentally realize long-time stroboscopic quantum dynamics of a periodically driven spin system consisting of 8 transmon qubits, and obtain a lifetime of the DTC order limited by the coherence time of the underlying physical platform. We also explore the crossover between the discrete TTS broken and unbroken phases via various physical signatures. Our work extends the usage of superconducting circuit systems in quantum simulation of many-body physics, and provides an experimental tool for investigating non-equilibrium dynamics and phase structures.
Significant progress has been made in building large-scale superconducting quantum processors based on flip-chip technology. In this work, we use the flip-chip technology to realizea modified transmon qubit, donated as the „flipmon“, whose large shunt capacitor is replaced by a vacuum-gap parallel plate capacitor. To further reduce the qubit footprint, we place one of the qubit pads and a single Josephson junction on the bottom chip and the other pad on the top chip which is galvanically connected with the single Josephson junction through an indium bump. The electric field participation ratio can arrive at nearly 53% in air when the vacuum-gap is about 5 microns, and thus potentially leading to a lower dielectric loss. The coherence times of the flipmons are measured in the range of 30-60 microseconds, which are comparable with that of traditional transmons with similar fabrication processes. The electric field simulation indicates that the metal-air interface’s participation ratio increases significantly and may dominate the qubit’s decoherence. This suggests that more careful surface treatment needs to be considered. No evidence shows that the indium bumps inside the flipmons cause significant decoherence. With well-designed geometry and good surface treatment, the coherence of the flipmons can be further improved.
By using the dry etching process of tantalum (Ta) film, we had obtained transmon qubit with the best lifetime (T1) 503 us, suggesting that the dry etching process can be adopted inthe following multi-qubit fabrication with Ta film. We also compared the relaxation and coherence times of transmons made with different materials (Ta, Nb and Al) with the same design and fabrication processes of Josephson junction, we found that samples prepared with Ta film had the best performance, followed by those with Al film and Nb film. We inferred that the reason for this difference was due to the different loss of oxide materials located at the metal-air interface.