We draw analogies between protected superconducting qubits and bosonic qubits by studying the fluxonium Hamiltonian in its Fock basis. The mean-field phase diagram of fluxonium (atthe sweet spot) is identified, with a region in parameter space that is characterized by ℤ2-symmetry-broken ground states. In the heavy fluxonium limit, these ground states are well approximated by squeezed coherent states in a Fock basis (corresponding to persistent current states with definite flux but indefinite charge), and simple expressions are provided for them in terms of the circuit parameters. We study the noise bias in fluxonium via a universal Lindblad master equation and find that the bit-flip rate is exponentially small in Ej/(kBT), while the phase-flip rate does not get worse with this ratio. Analogous behavior is found in cos(2θ) qubits. We discuss first steps towards generating an Ising interaction between protected superconducting qubits on a two-dimensional lattice, with the aim of achieving a passive quantum memory by coupling a static Hamiltonian to a generic thermal bath.
Cat qubits, a type of bosonic qubit encoded in a harmonic oscillator, can exhibit an exponential noise bias against bit-flip errors with increasing mean photon number. Here, we focuson cat qubits stabilized by two-photon dissipation, where pairs of photons are added and removed from a harmonic oscillator by an auxiliary, lossy buffer mode. This process requires a large loss rate and strong nonlinearities of the buffer mode that must not degrade the coherence and linearity of the oscillator. In this work, we show how to overcome this challenge by coloring the loss environment of the buffer mode with a multi-pole filter and optimizing the circuit to take into account additional inductances in the buffer mode. Using these techniques, we achieve near-ideal enhancement of cat-qubit bit-flip times with increasing photon number, reaching over 0.1 seconds with a mean photon number of only 4. Concurrently, our cat qubit remains highly phase coherent, with phase-flip times corresponding to an effective lifetime of T1,eff≃70 μs, comparable with the bare oscillator lifetime. We achieve this performance even in the presence of an ancilla transmon, used for reading out the cat qubit states, by engineering a tunable oscillator-ancilla dispersive coupling. Furthermore, the low nonlinearity of the harmonic oscillator mode allows us to perform pulsed cat-qubit stabilization, an important control primitive, where the stabilization can remain off for a significant fraction (e.g., two thirds) of a 3 μs cycle without degrading bit-flip times. These advances are important for the realization of scalable error-correction with cat qubits, where large noise bias and low phase-flip error rate enable the use of hardware-efficient outer error-correcting codes.
The conditional displacement (CD) gate between an oscillator and a discrete-variable ancilla plays a key role in quantum information processing tasks, such as enabling universal controlof the oscillator and longitudinal readout of the qubit. However, the gate is unprotected against the propagation of ancilla decay errors and hence not fault-tolerant. Here, we propose a CD gate scheme with fluxonium as the ancilla, which has been experimentally demonstrated to have a large noise bias and millisecond-level lifetimes. The proposed gate is applied cross-resonantly by modulating the external flux of the fluxonium at the frequency of the target oscillator, which requires minimal hardware overhead and does not increase sensitivity to decoherence mechanisms like dephasing. We further provide a perturbative description of the gate mechanism and identify the error budget. Additionally, we develop an approximate procedure for choosing device and gate parameters that optimizes gate performance. Following the procedure for multiple sets of fluxonium parameters from the literature, we numerically demonstrate CD gates with unitary fidelity exceeding 99.9% and gate times of hundreds of nanoseconds.
We take a bottom-up, first-principles approach to design a two-qubit gate between fluxonium qubits for minimal error, speed, and control simplicity. Our proposed architecture consistsof two fluxoniums coupled via a linear resonator. Using a linear coupler introduces the possibility of material optimization for suppressing its loss, enables efficient driving of state-selective transitions through its large charge zero point fluctuation, reduces sensitivity to junction aging, and partially mitigates coherent coupling to two-level systems. Crucially, a resonator-as-coupler approach also suggests a clear path to increased connectivity between fluxonium qubits, by reducing capacitive loading when the coupler has a high impedance. After performing analytic and numeric analyses of the circuit Hamiltonian and gate dynamics, we tune circuit parameters to destructively interfere sources of coherent error, revealing an efficient, fourth-order scaling of coherent error with gate duration. For component properties from the literature, we predict an open-system average CZ gate infidelity of 1.86×10−4 in 70ns.
We present a comprehensive architectural analysis for a fault-tolerant quantum computer based on cat codes concatenated with outer quantum error-correcting codes. For the physical hardware,we propose a system of acoustic resonators coupled to superconducting circuits with a two-dimensional layout. Using estimated near-term physical parameters for electro-acoustic systems, we perform a detailed error analysis of measurements and gates, including CNOT and Toffoli gates. Having built a realistic noise model, we numerically simulate quantum error correction when the outer code is either a repetition code or a thin rectangular surface code. Our next step toward universal fault-tolerant quantum computation is a protocol for fault-tolerant Toffoli magic state preparation that significantly improves upon the fidelity of physical Toffoli gates at very low qubit cost. To achieve even lower overheads, we devise a new magic-state distillation protocol for Toffoli states. Combining these results together, we obtain realistic full-resource estimates of the physical error rates and overheads needed to run useful fault-tolerant quantum algorithms. We find that with around 1,000 superconducting circuit components, one could construct a fault-tolerant quantum computer that can run circuits which are intractable for classical supercomputers. Hardware with 32,000 superconducting circuit components, in turn, could simulate the Hubbard model in a regime beyond the reach of classical computing.
Single-photon detectors are ubiquitous and integral components of photonic quantum cryptography, communication, and computation. Many applications, however, require not only detectingthe presence of any photons, but distinguishing the number present with a single shot. Here, we implement a single-shot, high-fidelity photon number-resolving detector of up to 15 microwave photons in a cavity-qubit circuit QED platform. This detector functions by measuring a series of generalized parity operators which make up the bits in the binary decomposition of the photon number. Our protocol consists of successive, independent measurements of each bit by entangling the ancilla with the cavity, then reading out and resetting the ancilla. Photon loss and ancilla readout errors can flip one or more bits, causing nontrivial errors in the outcome, but these errors have a traceable form which can be captured in a simple hidden Markov model. Relying on the independence of each bit measurement, we mitigate biases in the measurement result, showing good agreement with the predictions of the model. The mitigation improves the average total variation distance error of Fock states from 13.5% to 1.3%. We also show that the mitigation is efficiently scalable to an M-mode system provided that the errors are independent and sufficiently small. Our work motivates the development of new algorithms that utilize single-shot, high-fidelity PNR detectors.
Qubit measurements are central to quantum information processing. In the field of superconducting qubits, standard readout techniques are not only limited by the signal-to-noise ratio,but also by state relaxation during the measurement. In this work, we demonstrate that the limitation due to relaxation can be suppressed by using the many-level Hilbert space of superconducting circuits: in a multilevel encoding, the measurement is only corrupted when multiple errors occur. Employing this technique, we show that we can directly resolve transmon gate errors at the level of one part in 103. Extending this idea, we apply the same principles to the measurement of a logical qubit encoded in a bosonic mode and detected with a transmon ancilla, implementing a proposal by Hann et al. [Phys. Rev. A \textbf{98} 022305 (2018)]. Qubit state assignments are made based on a sequence of repeated readouts, further reducing the overall infidelity. This approach is quite general and several encodings are studied; the codewords are more distinguishable when the distance between them is increased with respect to photon loss. The tradeoff between multiple readouts and state relaxation is explored and shown to be consistent with the photon-loss model. We report a logical assignment infidelity of 5.8×10−5 for a Fock-based encoding and 4.2×10−3 for a QEC code (the S=2,N=1 binomial code). Our results will not only improve the fidelity of quantum information applications, but also enable more precise characterization of process or gate errors.
Hybrid quantum systems in which acoustic resonators couple to superconducting qubits are promising quantum information platforms. High quality factors and small mode volumes make acousticmodes ideal quantum memories, while the qubit-phonon coupling enables the initialization and manipulation of quantum states. We present a scheme for quantum computing with multimode quantum acoustic systems, and based on this scheme, propose a hardware-efficient implementation of a quantum random access memory (qRAM). Quantum information is stored in high-Q phonon modes, and couplings between modes are engineered by applying off-resonant drives to a transmon qubit. In comparison to existing proposals that involve directly exciting the qubit, this scheme can offer a substantial improvement in gate fidelity for long-lived acoustic modes. We show how these engineered phonon-phonon couplings can be used to access data in superposition according to the state of designated address modes–implementing a qRAM on a single chip.
High-fidelity qubit measurements play a crucial role in quantum computation, communication, and metrology. In recent experiments, it has been shown that readout fidelity may be improvedby performing repeated quantum non-demolition (QND) readouts of a qubit’s state through an ancilla. For a qubit encoded in a two-level system, the fidelity of such schemes is limited by the fact that a single error can destroy the information in the qubit. On the other hand, if a bosonic system is used, this fundamental limit could be overcome by utilizing higher levels such that a single error still leaves states distinguishable. In this work, we present a robust readout scheme, applicable to bosonic systems dispersively coupled to an ancilla, which leverages both repeated QND readouts and higher-level encodings to asymptotically suppress the effects of qubit/cavity relaxation and individual measurement infidelity. We calculate the measurement fidelity in terms of general experimental parameters, provide an information-theoretic description of the scheme, and describe its application to several encodings, including cat and binomial codes.