We demonstrate a qubit-readout architecture where the dispersive coupling is entirely mediated by a kinetic inductance. This allows us to engineer the dispersive shift of the readoutresonator independent of the qubit and resonator capacitances. We validate the pure kinetic coupling concept and demonstrate various generalized flux qubit regimes from plasmon to fluxon, with dispersive shifts ranging from 60 kHz to 2 MHz at the half-flux quantum sweet spot. We achieve readout performances comparable to conventional architectures with quantum state preparation fidelities of 99.7 % and 92.7 % for the ground and excited states, respectively, and below 0.1 % leakage to non-computational states.
An accurate understanding of the Josephson effect is the keystone of quantum information processing with superconducting hardware. Here we show that the celebrated sinφ current-phaserelation (CφR) of Josephson junctions (JJs) fails to fully describe the energy spectra of transmon artificial atoms across various samples and laboratories. While the microscopic theory of JJs contains higher harmonics in the CφR, these have generally been assumed to give insignificant corrections for tunnel JJs, due to the low transparency of the conduction channels. However, this assumption might not be justified given the disordered nature of the commonly used AlOx tunnel barriers. Indeed, a mesoscopic model of tunneling through an inhomogeneous AlOx barrier predicts contributions from higher Josephson harmonics of several %. By including these in the transmon Hamiltonian, we obtain orders of magnitude better agreement between the computed and measured energy spectra. The measurement of Josephson harmonics in the CφR of standard tunnel junctions prompts a reevaluation of current models for superconducting hardware and it offers a highly sensitive probe towards optimizing tunnel barrier uniformity.
The innate complexity of solid state physics exposes superconducting quantum circuits to interactions with uncontrolled degrees of freedom degrading their coherence. By using a simplestabilization sequence we show that a superconducting fluxonium qubit is coupled to a two-level system (TLS) environment of unknown origin, with a relatively long energy relaxation time exceeding 50ms. Implementing a quantum Szilard engine with an active feedback control loop allows us to decide whether the qubit heats or cools its TLS environment. The TLSs can be cooled down resulting in a four times lower qubit population, or they can be heated to manifest themselves as a negative temperature environment corresponding to a qubit population of ∼80%. We show that the TLSs and the qubit are each other’s dominant loss mechanism and that the qubit relaxation is independent of the TLS populations. Understanding and mitigating TLS environments is therefore not only crucial to improve qubit lifetimes but also to avoid non-Markovian qubit dynamics.
We demonstrate flux-bias locking and operation of a gradiometric fluxonium artificial atom using two symmetric granular aluminum (grAl) loops to implement the superinductor. The gradiometricfluxonium shows two orders of magnitude suppression of sensitivity to homogeneous magnetic fields, which can be an asset for hybrid quantum systems requiring strong magnetic field biasing. By cooling down the device in an external magnetic field while crossing the metal-to-superconductor transition, the gradiometric fluxonium can be locked either at 0 or Φ0/2 effective flux bias, corresponding to an even or odd number of trapped fluxons, respectively. At mK temperatures, the fluxon parity prepared during initialization survives to magnetic field bias exceeding 100Φ0. However, even for states biased in the vicinity of 1Φ0, we observe unexpectedly short fluxon lifetimes of a few hours, which cannot be explained by thermal or quantum phase slips. When operating in a deep-underground cryostat of the Gran Sasso laboratory, the fluxon lifetimes increase to days, indicating that ionizing events activate phase slips in the grAl superinductor.
Reading out the state of superconducting artificial atoms typically relies on dispersive coupling to a readout resonator. For a given system noise temperature, increasing the circulatingphoton number n¯ in the resonator enables a shorter measurement time and is therefore expected to reduce readout errors caused by spontaneous atom transitions. However, increasing n¯ is generally observed to also increase these transition rates. Here we present a fluxonium artificial atom in which we measure an overall flat dependence of the transition rates between its first two states as a function of n¯, up to n¯≈200. Despite the fact that we observe the expected decrease of the dispersive shift with increasing readout power, the signal-to-noise ratio continuously improves with increasing n¯. Even without the use of a parametric amplifier, at n¯=74, we measure fidelities of 99% and 93% for feedback-assisted ground and excited state preparation, respectively.
As quantum coherence times of superconducting circuits have increased from nanoseconds to hundreds of microseconds, they are currently one of the leading platforms for quantum informationprocessing. However, coherence needs to further improve by orders of magnitude to reduce the prohibitive hardware overhead of current error correction schemes. Reaching this goal hinges on reducing the density of broken Cooper pairs, so-called quasiparticles. Here, we show that environmental radioactivity is a significant source of nonequilibrium quasiparticles. Moreover, ionizing radiation introduces time-correlated quasiparticle bursts in resonators on the same chip, further complicating quantum error correction. Operating in a deep-underground lead-shielded cryostat decreases the quasiparticle burst rate by a factor fifty and reduces dissipation up to a factor four, showcasing the importance of radiation abatement in future solid-state quantum hardware.
We developed a versatile integrated control and readout instrument for experiments with superconducting quantum bits (qubits), based on a field-programmable gate array (FPGA) platform.Using this platform, we perform measurement-based, closed-loop feedback operations with 428ns platform latency. The feedback capability is instrumental in realizing active reset initialization of the qubit into the ground state in a time much shorter than its energy relaxation time T1. We show experimental results demonstrating reset of a fluxonium qubit with 99.4% fidelity, using a readout-and-drive pulse sequence approximately 1.5μs long. Compared to passive ground state initialization through thermalization, with the time constant given by T1= 80μs, the use of the FPGA-based platform allows us to improve both the fidelity and the time of the qubit initialization by an order of magnitude.
The high kinetic inductance offered by granular aluminum (grAl) has recently been employed for linear inductors in superconducting high-impedance qubits and kinetic inductance detectors.Due to its large critical current density compared to typical Josephson junctions, its resilience to external magnetic fields, and its low dissipation, grAl may also provide a robust source of non-linearity for strongly driven quantum circuits, topological superconductivity, and hybrid systems. Having said that, can the grAl non-linearity be sufficient to build a qubit? Here we show that a small grAl volume (10×200×500nm3) shunted by a thin film aluminum capacitor results in a microwave oscillator with anharmonicity α two orders of magnitude larger than its spectral linewidth Γ01, effectively forming a transmon qubit. With increasing drive power, we observe several multi-photon transitions starting from the ground state, from which we extract α=2π×4.48MHz. Resonance fluorescence measurements of the |0>→|1> transition yield an intrinsic qubit linewidth γ=2π×10kHz, corresponding to a lifetime of 16μs. This linewidth remains below 2π×150kHz for in-plane magnetic fields up to ∼70mT.
Determining the state of a qubit on a timescale much shorter than its relaxation time is an essential requirement for quantum information processing. With the aid of a new type of non-degenerateparametric amplifier, we demonstrate the continuous detection of quantum jumps of a transmon qubit with 90% fidelity in state discrimination. Entirely fabricated with standard two-step optical lithography techniques, this type of parametric amplifier consists of a dispersion engineered Josephson junction (JJ) array. By using long arrays, containing 103 JJs, we can obtain amplification at multiple eigenmodes with frequencies below 10 GHz, which is the typical range for qubit readout. Moreover, by introducing a moderate flux tunability of each mode, employing superconducting quantum interference device (SQUID) junctions, a single amplifier device could potentially cover the entire frequency band between 1 and 10 GHz.
Superconducting granular aluminum is attracting increasing interest due to its high kinetic inductance and low dissipation, favoring its use in kinetic inductance particle detectors,superconducting resonators or quantum bits. We perform switching current measurements on DC-SQUIDs, obtained by introducing two identical geometric constrictions in granular aluminum rings of various normal-state resistivities in the range from ρn=250μΩcm to 5550μΩcm. The relative high kinetic inductance of the SQUID loop, in the range of tens of nH, leads to a suppression of the modulation in the measured switching current versus magnetic flux, accompanied by a distortion towards a triangular shape. We observe a change in the temperature dependence of the switching current histograms with increasing normal-state film resistivity. This behavior suggests the onset of a diffusive motion of the superconducting phase across the constrictions in the two-dimensional washboard potential of the SQUIDs, which could be caused by a change of the local electromagnetic environment of films with increasing normal-state resistivities.