Accurate control of qubits is the central requirement for building functional quantum processors. For the current superconducting quantum processor, high-fidelity control of qubitsis mainly based on independently calibrated microwave pulses, which could differ from each other in frequencies, amplitudes, and phases. With this control strategy, the needed physical source could be challenging, especially when scaling up to large-scale quantum processors is considered. Inspired by Kane’s proposal for spin-based quantum computing, here, we explore theoretically the possibility of baseband flux control of superconducting qubits with only shared and always-on microwave drives. In our strategy, qubits are by default far detuned from the drive during system idle periods, qubit readout and baseband flux-controlled two-qubit gates can thus be realized with minimal impacts from the always-on drive. By contrast, during working periods, qubits are tuned on resonance with the drive and single-qubit gates can be realized. Therefore, universal qubit control can be achieved with only baseband flux pulses and always-on shared microwave drives. We apply this strategy to the qubit architecture where tunable qubits are coupled via a tunable coupler, and the analysis shows that high-fidelity qubit control is possible. Besides, the baseband control strategy needs fewer physical resources, such as control electronics and cooling power in cryogenic systems, than that of microwave control. More importantly, the flexibility of baseband flux control could be employed for addressing the non-uniformity issue of superconducting qubits, potentially allowing the realization of multiplexing and cross-bar technologies and thus controlling large numbers of qubits with fewer control lines. We thus expect that baseband control with shared microwave drives can help build large-scale superconducting quantum processors.
With the long coherence time, fixed-frequency transmon qubit is a promising qubit modality for quantum computing. Currently, diverse qubit architectures that utilize fixed-frequencytransmon qubits have been demonstrated with high-fidelity gate performance. Nevertheless, the relaxation times of transmon qubits can have large temporal fluctuations, causing instabilities in gate performance. The fluctuations are often believed to be caused by nearly on-resonance couplings with sparse two-level-system (TLS) defects. To mitigate their impact on qubit coherence and gate performance, one direct approach is to tune the qubits away from these TLSs. In this work, to combat the potential TLS-induced performance fluctuations in a tunable-bus architecture unitizing fixed-frequency transmon qubits, we explore the possibility of using an off-resonance microwave drive to effectively tuning the qubit frequency through the ac-Stark shift while implementing universal gate operations on the microwave-dressed qubit. We show that the qubit frequency can be tuned up to 20 MHz through the ac-stark shift while keeping minimal impacts on the qubit control. Besides passive approaches that aim to remove these TLSs through more careful treatments of device fabrications, this work may offer an active approach towards mitigating the TLS-induced performance fluctuations in fixed-frequency transmon qubit devices.
Significant progress has been made in building large-scale superconducting quantum processors based on flip-chip technology. In this work, we use the flip-chip technology to realizea modified transmon qubit, donated as the „flipmon“, whose large shunt capacitor is replaced by a vacuum-gap parallel plate capacitor. To further reduce the qubit footprint, we place one of the qubit pads and a single Josephson junction on the bottom chip and the other pad on the top chip which is galvanically connected with the single Josephson junction through an indium bump. The electric field participation ratio can arrive at nearly 53% in air when the vacuum-gap is about 5 microns, and thus potentially leading to a lower dielectric loss. The coherence times of the flipmons are measured in the range of 30-60 microseconds, which are comparable with that of traditional transmons with similar fabrication processes. The electric field simulation indicates that the metal-air interface’s participation ratio increases significantly and may dominate the qubit’s decoherence. This suggests that more careful surface treatment needs to be considered. No evidence shows that the indium bumps inside the flipmons cause significant decoherence. With well-designed geometry and good surface treatment, the coherence of the flipmons can be further improved.
By using the dry etching process of tantalum (Ta) film, we had obtained transmon qubit with the best lifetime (T1) 503 us, suggesting that the dry etching process can be adopted inthe following multi-qubit fabrication with Ta film. We also compared the relaxation and coherence times of transmons made with different materials (Ta, Nb and Al) with the same design and fabrication processes of Josephson junction, we found that samples prepared with Ta film had the best performance, followed by those with Al film and Nb film. We inferred that the reason for this difference was due to the different loss of oxide materials located at the metal-air interface.
High fidelity two-qubit gates are fundamental for scaling up the superconducting number. We use two qubits coupled via a frequency-tunable coupler which can adjust the coupling strength,and demonstrate the CZ gate using two different schemes, adiabatic and di-adiabatic methods. The Clifford based Randomized Benchmarking (RB) method is used to assess and optimize the CZ gate fidelity. The fidelity of adiabatic and di-adiabatic CZ gates are 99.53(8)% and 98.72(2)%, respectively. We also analyze the errors induced by the decoherence, which are 92% of total for adiabatic CZ gate and 46% of total for di-adiabatic CZ gates. The adiabatic scheme is robust against the operation error. But the di-adiabatic scheme is sensitive to the purity and operation errors. Comparing to 30 ns duration time of adiabatic CZ gate, the duration time of di-adiabatic CZ gate is 19 ns, revealing lower incoherence error rincoherent,Clfford = 0.0197(5) than r′incoherent,Clfford = 0.0223(3).