We present a control and measurement setup for superconducting qubits based on Xilinx 16-channel radio frequency system on chip (RFSoC) device. The proposed setup consists of four parts:multiple RFSoC FPGA boards, a setup to synchronise every DAC and ADC channel across multiple boards, a low-noise DC current supply for qubit biasing and cloud access for remotely performing experiments. We also design the setup to be free of physical mixers. The FPGA boards directly generate microwave pulses using sixteen DAC channels up to the third Nyquist zone which are directly sampled by its eight ADC channels between the fifth and the ninth zones.
A challenge in the Gauss sums factorization scheme is the presence of ghost factors – non-factors that behave similarly to actual factors of an integer – which might leadto the misidentification of non-factors as factors or vice versa, especially in the presence of noise. We investigate Type II ghost factors, which are the class of ghost factors that cannot be suppressed with techniques previously laid out in the literature. The presence of Type II ghost factors and the coherence time of the qubit set an upper limit for the total experiment time, and hence the largest factorizable number with this scheme. Discernability is a figure of merit introduced to characterize this behavior. We introduce preprocessing as a strategy to increase the discernability of a system, and demonstrate the technique with a transmon qubit. This can bring the total experiment time of the system closer to its decoherence limit, and increase the largest factorizable number.
Using a home-built Ku band ESR spectrometer equipped with an arbitrary waveform generator and a stripline resonator, we implement two types of pulses that would benefit quantum computers:BB1 composite pulse and a microwave frequency comb. Broadband type 1 (BB1) composite pulse is commonly used to combat systematic errors but previous experiments were carried out only on extremely narrow linewidth samples. Using a sample with a linewidth of 9.35 MHz, we demonstrate that BB1 composite pulse is still effective against pulse length errors at a Rabi frequency of 38.46 MHz. The fast control is realized with low microwave power which is required for initialization of electron spin qubits at 0.6 T. We also digitally design and implement a microwave frequency comb to excite multiple spin packets of a different sample. Using this pulse, we demonstrate coherent and well resolved excitations spanning over the entire spectrum of the sample (ranging from -20 to 20 MHz). In anticipation of scaling up to a system with large number of qubits, this approach provides an efficient technique to selectively and simultaneously control multiple qubits defined in the frequency-domain.
Hybrid quantum systems have the potential of mitigating current challenges in developing a scalable quantum computer. Of particular interest is the hybridization between atomic andsuperconducting qubits. We demonstrate a novel experimental setup for transferring and trapping ultracold atoms inside a millikelvin cryogenic environment, where interactions between atomic and superconducting qubits can be established, paving the way for hybrid quantum systems. 87Rb atoms are prepared in a conventional magneto-optical trap and transported via a magnetic conveyor belt into a UHV compatible dilution refrigerator with optical access. We store 5×108 atoms with a lifetime of 794 seconds in the vicinity of the millikelvin stage.