Properties of superconducting devices depend sensitively on the parity (even or odd) of the quasiparticles they contain. Encoding quantum information in the parity degree of freedomis central in several emerging solid-state qubit architectures. Yet, accurate, non-destructive, and time-resolved parity measurement is a challenging and long-standing issue. Here we report on control and real-time parity measurement in a superconducting island embedded in a superconducting loop and realized in a hybrid two-dimensional heterostructure using a microwave resonator. Device and readout resonator are located on separate chips, connected via flip-chip bonding, and couple inductively through vacuum. The superconducting resonator detects the parity-dependent circuit inductance, allowing for fast and non-destructive parity readout. We resolved even and odd parity states with signal-to-noise ratio SNR ≈3 with an integration time of 20 μs and detection fidelity exceeding 98%. Real-time parity measurement showed state lifetime extending into millisecond range. Our approach will lead to better understanding of coherence-limiting mechanisms in superconducting quantum hardware and provide novel readout schemes for hybrid qubits.
Semiconductor qubits rely on the control of charge and spin degrees of freedom of electrons or holes confined in quantum dots (QDs). They constitute a promising approach to quantuminformation processing [1, 2], complementary to superconducting qubits [3]. Typically, semiconductor qubit-qubit coupling is short range [1, 2, 4, 5], effectively limiting qubit distance to the spatial extent of the wavefunction of the confined particle, which represents a significant constraint towards scaling to reach dense 1D or 2D arrays of QD qubits. Following the success of circuit quantum eletrodynamics [6], the strong coupling regime between the charge [7, 8] and spin [9, 10, 11] degrees of freedom of electrons confined in semiconducting QDs interacting with individual photons stored in a microwave resonator has recently been achieved. In this letter, we demonstrate coherent coupling between a superconducting transmon qubit and a semiconductor double quantum dot (DQD) charge qubit mediated by virtual microwave photon excitations in a tunable high-impedance SQUID array resonator acting as a quantum bus [12, 13, 14]. The transmon-charge qubit coherent coupling rate (∼21 MHz) exceeds the linewidth of both the transmon (∼0.8 MHz) and the DQD charge (∼3 MHz) qubit. By tuning the qubits into resonance for a controlled amount of time, we observe coherent oscillations between the constituents of this hybrid quantum system. These results enable a new class of experiments exploring the use of the two-qubit interactions mediated by microwave photons to create entangled states between semiconductor and superconducting qubits. The methods and techniques presented here are transferable to QD devices based on other material systems and can be beneficial for spin-based hybrid systems.
Developing fast and accurate control and readout techniques is an important challenge in quantum information processing with semiconductor qubits. Here, we study the dynamics and thecoherence properties of a GaAs/AlGaAs double quantum dot (DQD) charge qubit strongly coupled to a high-impedance SQUID array resonator. We drive qubit transitions with synthesized microwave pulses and perform qubit readout through the state dependent frequency shift imparted by the qubit on the dispersively coupled resonator. We perform Rabi oscillation, Ramsey fringe, energy relaxation and Hahn-echo measurements and find significantly reduced decoherence rates down to γ2/2π∼3MHz corresponding to coherence times of up to T2∼50ns for charge states in gate defined quantum dot qubits.