Florian Blanchet

Multiplexed readout of ultrasensitive bolometers

  1. Priyank Singh,
  2. András Gunyhó,
  3. Heikki Suominen,
  4. Giacomo Catto,
  5. Florian Blanchet,
  6. Qi-Ming Chen,
  7. Arman Alizadeh,
  8. Aarne Keränen,
  9. Jian Ma,
  10. Timm Mörstedt,
  11. Wei Liu,
  12. and Mikko Möttonen
Recently, ultrasensitive calorimeters have been proposed as a resource-efficient solution for multiplexed qubit readout in superconducting large-scale quantum processors. However, experiments
demonstrating frequency multiplexing of these superconductor-normal conductor-superconductor (SNS) sensors are coarse. To this end, we present the design, fabrication, and operation of three SNS sensors with frequency-multiplexed input and probe circuits, all on a single chip. These devices have their probe frequencies in the range \SI{150}{\mega\hertz} — \SI{200}{\mega\hertz}, which is well detuned from the heater frequencies of \SI{4.4}{\giga\hertz} — \SI{7.6}{\giga\hertz} compatible with typical readout frequencies of superconducting qubits. Importantly, we show on-demand triggering of both individual and multiple low-noise SNS bolometers with very low cross talk. These experiments pave the way for multiplexed bolometric characterization and calorimetric readout of multiple qubits, a promising step in minimizing related resources such as the number of readout lines and microwave isolators in large-scale superconducting quantum computers.
arxiv pdf

Microwave photon-number amplification

  1. Romain Albert,
  2. Joël Griesmar,
  3. Florian Blanchet,
  4. Ulrich Martel,
  5. Nicolas Bourlet,
  6. and Max Hofheinz
So far, quantum-limited power meters are not available in the microwave domain, hindering measurement of photon number in itinerant quantum states. On the one hand, single photon detectors
accurately detect single photons, but saturate as soon as two photons arrive simultaneously. On the other hand, more linear watt meters, such as bolometers, are too noisy to accurately detect single microwave photons. Linear amplifiers probe non-commuting observables of a signal so that they must add noise and cannot be used to detect single photons, either. Here we experimentally demonstrate a microwave photon-multiplication scheme which combines the advantages of a single photon detector and a power meter by multiplying the incoming photon number by an integer factor. Our first experimental implementation achieves a n = 3-fold multiplication with 0.69 efficiency in a 116 MHz bandwidth up to a input photon rate of 400 MHz. It loses phase information but does not require any dead time or time binning. We expect an optimised device cascading such multipliers to achieve number-resolving measurement of itinerant photons with low dark count, which would offer new possibilities in a wide range of quantum sensing and quantum computing applications.
arxiv pdf